WATER, MOISTURE AND HEAT DAMAGE: Keep all components
away from water (sink, bath tub, swimming pool) and places that
emit heat (stove, radiator).
VENTILATION: ALWAYS place both units on a flat surface in an
upright position so that air can flow freely around them.
AC POWER SOURCE: Use only the AC adaptors supplied with the
Angelcare
®
Monitor.
CORD PROTECTION : Avoid damage to the adapter cords. Route
cords so that they are not likely to be walked on or pinched by
items placed on or against them.
CLEANING: Disconnect all units before cleaning. DO NOT
immerse in water. Use a dry cloth to keep monitor free from dust.
TROUBLESHOOTING
Problem
No sound is being transmitted.
Power ON indicator (green light)
E
does not light up.
Display is not activated on the
N
Parent Unit.
Night light does not light.
Very weak reception.
Static, distortion, interference
(interference from other monitors,
wireless phones, walkie-talkies,
etc...).
Feedback (loud noises emitted from
Parent Unit).
DO NOT spray with cleaning products or solvents. Wipe with a
very slightly damp cloth with an antiseptic or mild detergent.
OBJECT AND LIQUID ENTRY: Care should be taken so that
objects do not fall onto units and that liquids are not spilled into
either unit through openings.
NON-USE PERIODS: When not using the monitor for a short
period, make sure to turn the units OFF before disconnecting
them, otherwise the units will revert to the battery mode. When
not using monitor for long periods, remove the batteries from
both units and disconnect the AC adapters from electrical outlet.
Possible Cause
• Units are too far apart.
• Batteries are low or improperly installed.
• AC adaptors are not connected properly or
electrical
outlet is out of order.
• One of the units is OFF.
• Batteries are low or improperly installed.
• AC adapters are not connected properly or electrical
outlet is out of order.
•The Nursery Unit is at OFF position ("O").
• Night light is not turned ON
• Night light LED is burned
• Units are too far apart (out of range indicator will flash and
beep on the Parent Unit).
• One or both units are placed near a large metal mass.
• One or both units are not in the upright position.
• Batteries are low.
• Parent Unit is out of range.
• Parent Unit is located near motorized devices, fluorescent
lights, television, etc...
• Units are too close to each other.
• Volume is too high on the Parent Unit.
12
Solution
• Bring Parent Unit closer to Nursery Unit.
• Check/replace batteries or recharge Parent Unit.
• Check connections or change to another electrical
outlet.
• Ensure both units are ON.
• Check the microphone sensitivity dial.
• Check/replace batteries or recharge Parent Unit
• Check connections or change to another electrical
outlet.
• Make sure Nursery Unit is ON (Left wing on "-"
position).
• Press on the top clear button on the Nursery Unit
• Contact your distributor.
• Bring units closer together.
• Change the position of one or both units.
• Place units on flat surface away from baby's reach.
• Replace the batteries in the Nursery Unit or recharge
the Parent Unit.
• Bring units closer together.
• Activate the out of range indicator on the Nursery Unit
(left wing up).
• Rotate Parent Unit or move it away from source of inter-
ference.
• Move units farther apart (at least 3 meters/10 feet apart).
• Decrease volume on Parent Unit.