Instructions For Correct Use, Safety Instructions; Warranty - Brill 400 HS Mode D'emploi

9. Instructions for Correct Use, Safety Instructions

Check each time you use
A
the equipment
Inspect the equipment each time
before you use it. Do not use
the equipment if safety devices
(switch handle, safety covers)
and/or if the cutting device is
damaged or worn. Never dis-
able safety devices.
Check the cutting tools regularly
for damage and have them
repaired correctly if necessary.
Only have cutting tools replaced
by Brill Service or your autho-
rised specialist dealer.
A
Use / Responsibility
Powered equipment can cause
serious injuries! You are respon-
sible for safety in the area where
you are working.
Always use the equipment solely
for the purpose described in the
operating instructions.
Only use these hedge trimmers
in daylight or when the area

Warranty

The manufacturer warrants its
products for exclusively non-
commercial use for a period of
60 months from the date of orig-
inal purchase.
This warranty does not affect
statutory warranty claims. The
warranty covers all substantial
faults of the product, which are
caused by defects in material
and workmanship. If a product
exhibits such a defect we will,
at our option, repair or replace
it without cost for parts and
labour provided the following
requirements are fulfilled:
where you are working is lit by
ample artificial lighting.
Be careful if you are going back-
wards, risk of stumbling!
Only push the equipment at
walking pace.
Never use the machine with
damaged protective devices or
without protective devices.
When starting or operating the
starter switch take care as stipu-
lated by the manufacturer's
instructions. Ensure that your feet
are far enough away from the
cutting tool.
Keep your fingers and feet away
from the cutting tool!
If you strike an obstacle when
working, please disable the
machine. Unplug from the
mains. Remove the obstacle,
check the equipment for any
damage and have it repaired if
necessary.
If the equipment begins to
vibrate strongly, unplug from the
mains and ascertain the cause.
The product must have
.
been sold to the customer in
a legally correct way.
The original receipt with the
.
customer's address, date of
purchase, model and product
designation is presented as
proof of purchase. The product
must have been purchased
within the EC.
The product was handled
.
properly and according to the
recommendations in the oper-
ating instructions. It is essential
A
Taking a Break
Never leave the equipment
unattended. If you stop work,
unplug the equipment from the
mains and store the equipment
in a safe place.
If you stop work to go to a dif-
ferent work area, it is essential
to turn the equipment off and
unplug from the mains.
Always cover the cutting device
with the cutting device guard
when transporting or storing this
machine.
Beware of Environmental
A
Influences
Never use the equipment in the
rain or in damp, wet conditions.
Never work immediately
adjacent to a swimming pool
or garden pond with electrical
equipment.
Comply with local quiet periods
in your community!
that the product has been
maintained and cleaned
according to the information
in the operating instructions.
No attempt to disassemble or
repair the product has been
made by either the buyer or
an unauthorised third party.
It must be ensured that only
.
original replacement parts and
original accessories approved
by the manufacturer are used.
There may be an increased
risk of consequential damage
and accidents if non-original
GB
15