Inserting The Battery; Removing The Battery - Hilti SF 14-A Mode D'emploi

5.2 Inserting the battery

CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery
and the contacts on the product are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible
click.
3. Check that the battery is seated securely.

5.3 Removing the battery

1. Press the release buttons on the battery.
2. Pull the battery out of its holder in the device.
5.4 Adjusting the side handle
▶ Adjust the side handle to the desired position.
5.5 Fitting the belt hook (optional)
CAUTION
Risk of injury by falling power tools!
▶ Check that the belt hook is fitted securely before beginning work.
The belt hook enables you to attach suitable power tools to your belt, where
they are close to your body. It can be fitted to allow attachment on the left
or right side of the body.
1. Remove the battery from the power tool.
2. Secure the belt hook with 2 screws to the base of the power tool.
3. Check that belt hook and power tool are secure.
5.6 Fitting the accessory tool
1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Check that the connection end of the accessory tool is clean. Clean the
connection end if necessary.
3. Open the keyless chuck.
4. Insert the accessory tool into the keyless chuck and then turn the chuck
firmly by hand until tight and several clicks are heard.
5. Check that the accessory tool is held securely.
*2041323*
3
4
2041323 English 11