Charging The Battery; Fitting The Battery - Hilti SF 2-A Mode D'emploi

6.2 Charging the battery

DANGER
en
Use only the Hilti batteries and Hilti chargers listed under "Accessories".
6.2.1 Charging a new battery for the first time
Charge the battery fully before using it for the first time.
6.2.2 Charging a previously used battery
Ensure that the outer surfaces of the battery are clean and dry before
inserting it in the corresponding charger.
Information about charging can be found in the operating instructions for
the charger.
Lithium-ion batteries are ready for use even when only partially charged.

6.3 Fitting the battery

CAUTION
Before fitting the battery, check that the power tool is switched off and
that the safety lock is engaged (forward/reverse switch in the middle
position). Use only the Hilti batteries approved for use with this power
tool.
CAUTION
Before inserting the battery in the tool, check to ensure that the battery
terminals and the contacts in the tool are free from foreign objects.
1. Push the battery into the power tool from the front, as far as it will go,
and until it is heard to engage with a click.
2. CAUTION A falling battery may present a risk of injury to yourself and
others.
Check that the battery is seated securely in the power tool.
6.4 Removing the battery
1. Press the release button.
2. Pull the battery out of the tool towards the front.
38
Printed: 24.03.2014 | Doc-Nr: PUB / 5174884 / 000 / 00
All manuals and user guides at all-guides.com
2