Hilti SF 14-A Mode D'emploi page 19

Trouble or fault
The on/off button
cannot be pressed,
i.e. the button is
locked.
The battery runs
down more quickly
than usual.
The battery does
not engage with an
audible double click.
The tool or battery
gets very hot.
No hammering ac-
tion.
9.2 Disposal
Most of the materials from which Hilti tools and appliances are manu-
factured can be recycled. The materials must be correctly separated before
they can be recycled. In many countries, your old tools, machines or appli-
ances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti
representative for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking
gases or fluids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical
tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local govern-
mental garbage disposal or public health and safety resources for disposal
instructions.
*2041323*
Possible cause
The forward/reverse
selector switch is in the
middle position.
Very low ambient tem-
perature.
The retaining lugs on the
battery are dirty.
The tool is overloaded
(application limits ex-
ceeded).
The operating mode is
not set correctly at the
selector ring.
2041323
Action to be taken
▶ Push the
forward/reverse
switch to the left or
right.
▶ Allow the battery to
warm up slowly to
room temperature.
▶ Clean the retaining
lugs and push the
battery in until it
engages. Contact
Hilti Service if the
problem persists.
▶ Pay attention to the
power and perfor-
mance rating of the
product before using
it, i.e check its suitabil-
ity for the job on hand.
See the "Technical
data" section.
▶ Set the selector ring to
the "Hammer drilling"
position .
English 15