Invacare FUTURA R855 Manuel D'utilisation page 14

To attach the shower seat to the wall, take the fixing plate
l
to mark the holes out on the wall.
- Then place the plate at (H) height that has been determined
(see point 2)).
- Make sure the plate is level : all marks should be at the
same height.
- Drill the holes (drill diameter = 10 mm) in the wall and
insert raw plugs.
Screw the plate on the wall preferably using the screws sup-
plied in the standard tool set.
(except for R6600 model) (see figure 4)
12
Figure 3
O 10 x 65 mm
H
Figure 4
- Install the seat by sliding it into the fixing plate, push the
plate downwards and insert the set screws back.
(see figure 5)
- Fit the steel section provided with the set to hide the fixing
screws. If necessary, install the plate which links the backrest
to the seat (see figure 6)
To attach the backrest, take it out of the fixing plate by
l
pushing it upwards.Then slide the backrest fixing plate into
the linking plate rail.
- Use the fixing plate as a template to mark the holes out on
the wall.
Figure 5
Figure 6