Miranda ASD-711i Notice D'installation Et D'utilisation page 8

All manuals and user guides at all-guides.com
ASD ASD- - 711i/712i 711i/712i
2.3 Rear Panel Label
2.3.1 Quartet Frame
A connector label has been shipped with your ASD-711i or ASD-712i. This label is to be
connected on the Quartet tray rear panel in order to identify the ASD-711i or ASD-712i external
connectors. ASD-711i corresponds to only channel 1; ASD-712i corresponds to channel 1 and 2.
The-rear panel is always equipped with ASD-712i rear panel.
1. To install the label, follow these steps
2. On the tray's rear panel, locate the ASD-711i or ASD-712i connectors
3. Remove the screws as shown in the following diagram
4. Carefully, apply the label to the connectors
5. Replace the screws making sure not to damage the label.
Figure 2: Example of label installation
2.3.2 Symphonie Frame
To install the Symphonie label, follow these steps
while referring to Figure below
1. On Symphonie's rear panel, locate the
appropriate connectors.
2. Remove the rear label mounting screws
from the rear module.
3. Carefully apply the label to the connectors
making sure the label's text is read from
top to bottom.
4. Replace the screws making sure not to
damage the label.
Figure 3: Symphonie rear panel label installation
8
R e f e r e n c e M O D U L E L A B E L O R I E N T A T I O N M O D U L E 1