Miranda ASD-711i Notice D'installation Et D'utilisation page 16

All manuals and user guides at all-guides.com
ASD ASD- - 711i/712i 711i/712i
3.3 Menu introduction
Most ASD-711i or ASD-712i parameters are accessed and changed via an easy-to-use menu.
The flow chart of figure below outlines the entire ASD-711i or ASD-712i menu path. Each menu is
described throughout this section. The follow items should be remembered when accessing the
menu.
Automatic display turn off after 1-minute interval
If the menu is currently being accessed and no push-button has been pressed for 1 minute, the
ASD-711i or ASD-712i automatically turns off the display. A press on any push button [ + ], [ - ] or
[ SEL ] will turn on the display without any change on the current parameter.
Navigating through the menu
The front panel push buttons are used to navigate the menu. The following describes the function
of each push-button when navigating through the menu.
[ + ] Press [ + ] to move down in the menu or to increase the parameter value. For
example, if you are currently at I-1&2, pressing [ + ] will scroll downwards
through the selections I-1 and I-2.
Depressing [ + ] during an adjustment will increase the parameter value at faster
rate.
[ - ] Press [ - ] to move up in the menu or to decrease the parameter value. For
example, if you are currently at FREQ, pressing [ - ] will scroll through the
selections REF, TEST, MUTE and DITH.
Depressing [ - ] during an adjustment will decrease the parameter value at faster
rate.
[ SEL ] Changes to a menu parameter are stored immediately to non-volatile memory.
For example, after the L gain value has been set, press [ SEL] and the new
value is stored for the current format and ASD-711i or ASD-712i returns to
previous menu .
[ ESC ] If [ ESC ] is pressed after changes to a parameter, the parameter is reset to the
value it had prior to the change, For example, after changing L level, press [
ESC ] the previous value is reloaded and ASD-711i or ASD-712i returns to
previous menu. When on root menu, a press on [ ESC ] turns off the display.
Note: If the L and R values are different, the L value will be displayed after a L&R
selection. On the same way, the channel 1 value will be displayed after a I-1&2
or 0-1&2 selection.
16