Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
ASD
ASD- - 711i/712i
711i/712i
2 Installation
2.1 Unpacking
Make sure the following have been shipped with your ASD-711i or ASD-712i. If any of the
following items are missing, contact your distributor or Miranda Europe.
•
ASD-711i or ASD-712i
•
ASD-711i or ASD-712i rear panel labels
2.2 Mechanical installation
The ASD-711i or ASD-712i must be mounted within Quartet-A75 or-A110 tray or in Symphonie
R-A75 or R-A110 in order to provide power to the card.
This section describes how to install the ASD-711i or ASD-712i in any of these trays. It is not
necessary to switch off the power from these trays when installing the ASD-711i or ASD-712i
2.2.1 imaging Quartet series trays
To install this card into Quartet-A75 or Quartet-A110 follow these steps. For a closer look at card
installation and removal, refer to the tray's technical manual.
1.
Remove the tray's front panel by rotating the thumbscrews counter clockwise. Pull
on the handles.
2.
Select an empty slot
3.
Carefully place the ASD-711i or ASD-712i between a set of card guides and gently
push the card towards the rear of the tray until the card edge connector is secured
to the back plane. The card's edge connector having 96 points, it may be
necessary to push lightly when connecting the two connectors. Pull lightly on the
card verifying that it does not move.
4.
Replace the tray's front panel. Make sure to rotate the thumbscrews clockwise in
order to secure it to the chassis.
6
Publicité
Table des Matières
