Miranda ASD-711i Notice D'installation Et D'utilisation page 7

All manuals and user guides at all-guides.com
2.2.2 imaging Symphonie Housing Frame
It is not necessary to switch off the power when installing or removing a module from/to
Symphonie. To install a module, follow these steps. For a closer look at card installation and
removal, refer to the housing frame's Guide to Installation and Operation.
1. Open the front panel door by pulling on the door handles and gently lowering it.
2. Unscrew the bar.
3. Select an empty compartment. Make sure that the rear panel corresponds to the card to
install, and that configuration jumper of 5 BNC rear panel are in the proper position (LK1
switch: REFERENCE: LOCAL). A bad configuration will induce a malfunction.
Figure 1: rear panels for Symphonie
4. Carefully place the module between
the module guides and slowly push
the module towards the rear of the
frame until the
connector is secured to its rear
module. A light pressure to mate the
connectors may be required. Pull
lightly on the module verifying that it
does not move.
5. To install the Symphonie-R-M or Symphonie-R-A-75 rear module, refer to the housing
frame's Guide to Operation and Installation.
Replace the front panel door.
module's edge
7
ASD- - 711i/712i ASD 711i/712i