Table des Matières
Publicité
the blade's cutting capacity. That way you
will be able to ensure that no materials come
off that could cause accidents or injury.
2.3 45º cutting (miter)
Place the movable surface at 45º and lock
it using the positionable handles.
Position the cutting guide about 2 mm from
the diamond blade and lock it by fully
pressing in the knobs.
Position the tile with the enamel surface
facing the work surface and make sure that
the diamond blade does not come into
contact with the enamel of the tile.
If necessary, correct the position of the cutting
guide.
2.4 Switching on
When the machine is used outside, only use
extension cords that are designed for outside
use.
Make sure that the switch is in the 'off'
position when plugging in the machine.
The machine is started by pressing the green
or I button, and is switched off by pressing
the red or 0 button.
Once the machine is on, wait until the motor
speed stabilizes (2 or 3 seconds) before
starting to cut.
The machine is fitted with a safety system
against overheating of the motor, so if it stops
running for no apparent reason, wait a few
minutes for the safety system to be
deactivated, as it is highly probable that it
has been overforced and you should
therefore moderate the advance of the cut.
3. SAFETY INSTRUCTIONS
WARNING!
Important! When using electrical apparatus,
observe the following safety measures in order
to reduce the risk of electric discharge, injuries
and fire.
Read and observe all these instructions before
using the machine and keep these instructions
somewhere safe!
KEEP THESE INSTRUCTIONS SOMEWHERE
SAFE
ENGLISH
3.1 Keep your workplace tidy
An untidy workplace increases the risk of
accidents.
Keep the workplace well lit.
3.2 Consider working environment
Do not expose the machine to rain.
Do not use the machine in a wet or damp
environment. Make sure that the workplace
is well lit.
Do not use the machine near to inflammable
liquids or gasses.
3.3 Protect yourself against electric discharge
Avoid contact between the body and earthed
objects.
3.4 Keep children away!
Do not let other people touch the machine
or cable. Keep them away from your
workplace.
3.5 Store your tools in a safe place
Machines that are not being used should be
stored in a dry, safe place that is out of reach
of children.
3.6 Do not overload the machine
You will work better and more safely if you
do so within the indicated power margins.
3.7 Use the right machine
Do not use machines that are not powerful
enough or accessories that require more
power. Do not use the machine for jobs that
it was not designed for.
3.8 Wear the right work clothes
When working outdoors, you should wear
rubber gloves and footwear with non-slip
soles. If you have long hair, tie it up or use
a protective cap. Wear protective goggles.
Also use a facemask if the work you are
doing causes dust.
Use proper ear protection.
Do not wear baggy clothes or jewels that
could get caught in moving components.
Non-slip footwear is recommended when
working outdoors.
Use protective caps for long hair.
6
Publicité
Table des Matières
