Table des Matières
Publicité
Keep the grips dry, clean and remove any
oil or grease.
WARNING!
Before using the machine again, carefully check
to make sure that it works properly and will be
able to perform the function it was designed
for. Any damaged protection or other part should
be properly repaired or replaced using the
services of an authorized technician unless
indicated otherwise in this instruction manual.
Do not use the machine if it does not switch
on and off properly.
5. PRECAUTIONS
RECOMMENDATIONS!
The manufacturer accepts no responsibility for
the use of the ND-180-BL electric tile cutter
with different tools or for cutting unspecified
materials.
The ND-180-BL machine was designed exclusively
for use in accordance with the CONSENTED
OPERATION conditions indicated in the
"TECHNICAL DETAILS" paragraph. Therefore,
when cutting, position the machine as specified.
The ND-180-BL machine was not designed for
heavy and continued use.
All total or partial reproduction of the product,
in any format or any media or procedure, be
7. PROBLEM SOLVING
This electric tool complies with the relevant safety rules. Repairs should only be carried
out by qualified persons using original spare parts, otherwise this may result in considerable
danger to the user.
Problem
The machine does
not work
The machine does
not start properly
Without the previous authorisation of GERMANS BOADA, S.A., the partial or total reproduction of this manual, in any format or by any means
or process, is strictly prohibited, whether such reproduction be mechanical, photographic or electronic.
Any of these activities will incur legal liability and may give rise to penal action being taken.
Cause
The power cord is badly connected or
damaged
The power socket does not supply
The switch is damaged
The motor has no power and gives off
a bad smell
The diamond blade has bent due to
incorrect use
The starting capacitor is damaged
The motor's bearings are damaged
ENGLISH
it mechanical, photographic or electronic in
strictly forbidden without the prior authorization
of GERMANS BOADA S.A.
Any of these activities would be considered a
breach of legal responsibilities and could lead
to legal action.
GERMANS BOADA, S.A. reserves the right to
introduce any technical modifications without
prior warning.
5.1 Avoid risks
A-weighted equivalent pressure is lower at the
moment of making the cut at 70dB (A).
If the machines are used by the same operator
continuously for eight hours of work, this can
cause daily personal noise exposure of over
85dB(A).
To reduce the risks derived from noise
exposure, use appropriate ear plugs.
6. DECLARATION OF COMPLIANCE
WITH EEC REGULATIONS
This machine complies with regulations EN 61029-
1/2000, EN 12100-1-2/2003, EN 294/1992, EN 349/1993.
GERMANS BOADA S.A.
GERMANS BOADA S.A.
BARCELONA
P.O.BOX 14 - 08191 RUBI - SPAIN
Solution
Push the switch in fully, check the
power cord
Check the power socket
See a reliable salesperson
See a reliable salesperson
Change the diamond blade
See a reliable salesperson
See a reliable salesperson
Salvador Durán
Technical Director
8
Publicité
Table des Matières
