Sony KLH-40X1 Mode D'emploi page 47

STANDBY STANDBY
HD15 HD15 HDMI1 HDMI1
OPTION1 OPTION1 OPTION2 OPTION2
DISPLAY DISPLAY
ECO ECO
ON ON ID MODE ID MODE
RM-FW001 RM-FW001
Note
You cannot use the OPTION 2 button on this display.
9 ID MODE (ON/0-9/SET/C/OFF) buttons
ON ON
You can operate a specific display without affecting other displays
installed at the same time.
• ON button:
HDMI2 HDMI2
• 0-9 button:
to operate.
• SET button:
PICTURE PICTURE
• C button:
• OFF button: Press to return to the normal mode.
See page 16.
SOUND SOUND
+/– button
0
Adjusts the picture (contrast) level.
qa
OFF OFF
Press to adjust the volume.
qs
Press to mute the sound. Press again to restore sound.
qd ECO button
Press to reduce the power consumption by adjusting the backlight
brightness. This also enhances the black level. Select from "Off",
"Low", "High" or "Picture Off". See page 16.
SET SET
qf DISPLAY button
Press to display the currently selected input, the type of the input
signal and the "Wide Mode" setting on the screen. Press again to hide
them. If this displayed information is left undisturbed for a short time,
it will disappear automatically.
qg OPTION 1 button
Press to select the input signal of the VIDEO connector.
qh HD15 button
Press to select the input signal of the HD15 connector. The RGB
signal or component signal is selected automatically in accordance
with the connected equipment.
qj STANDBY button
Press to change the display to the standby mode.
Press to show the "Index Number" on the screen.
Press to enter the "Index Number" of the display you want
Press to set the input "Index Number".
Press to clear the input "Index Number".
+/– button
button
GB
13
GB