Rear Panel - Sony KLH-40X1 Mode D'emploi

Rear Panel

Connector
1 AC IN socket
2 Stand attachment hole
3 AUDIO (COMMON
AUDIO IN) (Stereo mini jack)
4 HD15 (RGB/
COMPONENT IN)
(D-sub 15-pin)
5 HDMI 1/HDMI 2 IN
6 S VIDEO IN
(Mini DIN 4-pin)
10
GB
1 2
Description
Connect the supplied AC power cord to this socket and to a wall outlet. Once you connect
the AC power cord, the STANDBY indicator lights up in red and the display goes into the
standby mode. See page 17.
Use this hole to secure the display on a table, etc. using an M6 screw.
Inputs an audio signal. Connects to the audio signal output of a piece of video equipment
or PC. Supports audio signals corresponding to 4 and 5.
Connects to the analog RGB signal or component signal output of a piece of video
equipment or PC. See page 31.
Note
When inputting a component signal, be sure not to input sync signals to pins 13 and 14. If
you do so, the picture may not be displayed properly.
HDMI (High-Definition Multimedia Interface) provides an interface between the display
and any HDMI-equipped audio/video equipment, as well as PC. You can enjoy enhanced
or high-definition video, and two-channel digital audio. You can also connect a piece of
DVI-equipped equipment to your display by using an HDMI-to-DVI cable (not supplied).
The appropriate mode for a piece of audio/video equipment or PC is automatically
selected in accordance with the connected equipment.
Note
Be sure to use only an HDMI cable that bears the HDMI logo.
Connects to the S Video output of a piece of video equipment.*
3
4
5
6
7
8
9
0