MaxLite M Serie Mode D'emploi page 9

Operating Instructions
MaxLite LED M-Series
®
Optional EM Installation:
If your fixture came with a pre-installed battery back-up unit, follow these steps to install.
1. Use a flat head screwdriver to remove the knockout cap from the back of the EM extension box (see FIG. 1).
2.
extension cover from the EM extension box (see FIG. 2).
Remove the twelve (12) M4 hex head screws and set aside for later use. Separate the fixture and EM
3.
Drill mounting holes in the EM extension box in the four (4) corners of the extension box for wall mounting.
to the mounting points on the intended junction box (see FIG. 3). Mount the extension box to the wall and
Drill through the raised hole locations on the junction box template in the center of the box that correspond
the junction box using these drilled holes. NOTE: mounting hardware not included.
4.
brackets to facilitate the wiring process (see FIG. 4).
Hook the fixture and EM extension cover onto the EM extension box. Allow the fixture to hang by the
5.
Pull the input wires through the hole in the EM extension box and complete the wiring connections
6.
following the wiring diagrams below (E0 or E2).
Replace the EM extension cover onto the extension box. Ensure that the gasket in-between the cover and
step 1 (see FIG. 5).
box fits in place. Secure the cover to the box using the twelve (12) M4 screws previously removed in
NOTE: Add a bead of exterior grade silicone sealant around the perimeter of the mount on the wall to inhibit any
moisture from attachment bolts.
FIG. 1
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
FIG. 2
M-Series
WALL MOUNTING LOCATIONS
J-BOX MOUNTING LOCATIONS
FIG. 3
Page: 9
REV: 06/02/21