MaxLite M Serie Mode D'emploi page 7

Operating Instructions
MaxLite LED M-Series
®
Installation & Operation
E: Fixed Wall Mount:
1. Remove the four (4) M5 hex head bolts. Remove the back plate from the wall mount (see FIG. 1).
2.
Drill holes in the 4 corner indentions to anchor the back plate to the wall. Drill holes on the J-Box mounting pattern to
match the J-Box. Note the 4 corner holes are to attach the fixture to the wall, the J-Box holes are to provide compression
to the wall. (see FIG. 2).
for the gasket to seal electrical connections. The J-Box mounting is not intended to be weight bearing and hold the fixture
NOTE: mounting hardware not included.
3.
hex head bolts removed in step 1 (see FIG. 3).
Connect the power leads to the driver compartment according to the wiring diagrams above. Retighten the four (4) M5
4.
5.
Use the side knockout holes for surface conduit installation.
Inspect installation to ensure the fixture is secure.
NOTE: Add a bead of exterior grade silicone sealant around the perimeter of the mount on the wall to inhibit any moisture from
attachment bolts.
BACK PLATE
FIG. 1
F: Variable Wall Mount:
1. Remove the four (4) M5 hex head bolts. Remove the back plate from the flexible wall mount (see FIG. 1).
2.
Drill holes in the 4 corner indentions to anchor the back plate to the wall. Drill holes on the J-Box mounting pattern to
match the J-Box. Note the 4 corner holes are to attach the fixture to the wall, the J-Box holes are to provide compression
to the wall. (see FIG. 2).
for the gasket to seal electrical connections. The J-Box mounting is not intended to be weight bearing and hold the fixture
NOTE: mounting hardware not included.
3.
hex head bolts removed in step 1 (see FIG. 3).
Connect the power leads to the driver compartment according to the wiring diagrams above. Retighten the four (4) M5
4.
5.
Use the side knockout holes for surface conduit installation.
desired angle (see FIG. 4).
To aim the fixture, remove the cover plate, loosen the M10 center knuckle bolt on the arm, adjust the arm to the
6. Inspect installation to ensure the fixture is secure (see FIG. 5).
NOTE: Add a bead of exterior grade silicone sealant around the perimeter of the mount on the wall to inhibit any moisture from
attachment bolts.
BACK PLATE
FIG. 1
FIG. 4
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
J-BOX MOUNTING LOCATIONS
M5 HEX HEAD BOLTS
M5 HEX HEAD BOLTS
M4
SCREWS
M10 BOLT
Wall Mounting
FIG. 2
Wall Mounting
J-BOX MOUNTING LOCATIONS
FIG. 2
FIG. 5
M-Series
FIG. 3
FIG. 3
Page: 7
REV: 06/02/21