MaxLite M Serie Mode D'emploi

Operating Instructions
MaxLite LED M-Series
®
General Safety Information
• This fixture is designed for outdoor lighting service, and should not be
used in areas of limited ventilation, or in high ambient temperatures.
• Before installing light fixtures, read and understand all cautions,
warnings, instructions, and product labels. Failure to do so could
result in injury and/or void the warranty.
• Installation should be done by a qualified electrician. Make sure power
is OFF before installing or maintaining fixture.
• Risk of injury or damage. Unit will fall if not installed properly.
Follow installation instructions.
• To reduce the risk of death, personal injury or property damage from fire,
electric shock, falling parts, cuts/abrasions, and other hazards read all
warnings and instructions included with and on the fixture box and all
fixture labels.
• Before installing, servicing, or performing routine maintenance upon
this equipment, follow these general precautions.
• Commercial installation, service and maintenance of luminaires
should be performed by a qualified licensed electrician.
• DO NOT INSTALL DAMAGED PRODUCT!
• This fixture is intended to be connected to a properly installed and grounded UL listed junction box.
WARNING:
RISK OF ELECTRICALSHOCK
• Turn off electrical power at fuse or circuit breaker box before wiring fixture
to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• Make all electrical and grounded connections in accordance with the National Electrical
Code and any applicable local code requirements.
• All wiring connections should be capped with UL approved wire connectors.
CAUTION:
RISK OF INJURY
• Unit will fall if not installed properly. Follow installation instructions.
• Wear gloves and safety glasses at all times when removing luminaire from carton, installing,
servicing or performing maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be hazardous to children.
CAUTION:
RISK OF FIRE
• Keep combustible and other materials that can burn away from luminaire and lamp/lens.
• MIN 90°C SUPPLY CONDUCTORS
Example: M40, M55, M75, M100, M125, M150, M200, M250, and M320 M-Series
Models:
Operating characteristics:
Operating temperature: -40°C to 40°C
Input voltage range: 100-277Vac, 277-480Vac, 50/60Hz
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
Picture is for illustration purposes only.
Your model may vary.
M-Series
Page: 1
REV: 06/02/21