MaxLite M Serie Mode D'emploi page 4

Operating Instructions
MaxLite LED M-Series
®
Follow the appropriate installation instructions based on your selected mounting method:
A. Straight Arm Mounting
D. Trunnion Mounting
Installation & Operation
A: Straight Arm Mount:
The fixture can be mounted to either a round or square pole with an adapter mounting plate. The mounting plate has a slot pattern
according to the pattern in FIG. 1. Install the mounting plate in accordance with FIG. 2.
that can cover many existing hole patterns. If there is no existing hole pattern or the holes are outside of the slot range, drill holes
.787 IN DIA
(20MM. DIA)
(HOLE)
FIG. 1
Three different adapter plates are available for round poles - 3", 4" and 5" RPA (Round Pole Adapters)
1. Tighten the nut plate and adapter on the pole (see FIG. 2).
2. Insert the fixture onto the adapter (see FIG. 3).
3.
Tighten the four (4) M8 bolts on the arm and secure it to the adapter. Connect the power leads properly
cover with the four (4) M4 screws (see FIG. 4). The wiring connections can also be made inside of the pole.
according to the wiring diagrams above. Make wiring connections inside the arm, and tighten the bottom
4. Inspect installation to ensure the fixture is secure (see FIG 5).
FIG. 3
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
B. Flexible Arm Mounting
E. Fixed Wall Mounting
Nut Plate
.312 IN DIA
(9MM. DIA)
(2 PLACES)
1.378 IN DIA
(35MM. DIA)
2.362 IN DIA
(60MM. DIA)
C. Slipfitter Mounting
F. Variable Wall Mounting
Silicone Pad Support Block
FIG. 2
FIG. 4
M-Series
FIG. 5
Page: 4
REV: 06/02/21