MaxLite M Serie Mode D'emploi page 6

Operating Instructions
MaxLite LED M-Series
®
Installation & Operation
C: Slipfitter Mount:
1.
insert the slipfitter onto the pole (see FIG. 1).
Connect the power supply wires to the fixture input wires (see Wiring Diagrams above). Lay the wires into the pole and
Note: fits over 2 3/8" - 3" OD tenons
2. Tighten the four (4) set screws on the slipfitter to secure it to the pole (refer to FIG. 2).
3.
desired angle (see FIG. 3).
To aim the fixture, remove the cover plate, loosen the M10 center knuckle bolt on the arm, adjust the arm to the
FIG. 1
D: Trunnion Mounting:
1. The trunnion bracket can be mounted using two (2) M12 bolts. Refer to FIG. 1 for drilling dimensions.
NOTE: Bolts not included. Provided by customer.
2.
3.
Once mounting hole(s) are drilled, secure the bracket with the fixture to the mounting surface.
fixture is set to the desired angle, retighten the socket head screws to secure the fixture (see FIG. 2).
Adjust the fixture to the desired angle by loosening the center bolts and removing the socket head screws. Once the
2.99 in
FIG. 1
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
FIG. 2
Ø .47 in
.59 in
Ø .67 in
Ø .67 in
M4 Screw
Cover Plate
M10 Bolt
FIG. 3
FIG. 2
M-Series
Socket Head Screw
Page: 6
REV: 06/02/21