MaxLite M Serie Mode D'emploi page 5

Operating Instructions
MaxLite LED M-Series
®
Installation & Operation
B: Flexible Arm Mount:
60° both upward and downward in 20° increments (see FIG. 1).The mounting plate has a slot pattern that can cover many existing
The fixture can be mounted to either a round or square pole with an adapter mounting plate. The flexible arm can be aimed 0 to
FIG. 2. Install the mounting plate in accordance with FIG. 3.
hole patterns. If there is no existing hole pattern or the holes are outside of the slot range, drill holes according to the pattern in
FIG. 1
Different adapters are available, including square pole adapter, 3" round pole adapter (RPA), 4" RPA, and 5" RPA.
1. Tighten the nut plate and adapter on the pole (see FIG. 3).
2. Insert the fixture onto the adapter (see FIG. 4).
3.
Tighten the four (4) M8 bolts on the arm and secure it to the adapter. Connect the power leads properly according to the
(see FIG. 5). The wiring connections can also be made inside of the pole.
wiring diagrams above. Make wiring connections inside the arm, and tighten the bottom cover with the four (4) M4 screws
4.
upward and downward to the desired angle (see FIG. 6).
To aim the fixture, remove the cover plate, loosen the M10 center knuckle bolt on the arm, adjust the aim 0 to 60° both
5. Inspect installation to ensure the fixture is secure (see FIG. 7).
FIG. 4
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
.787 IN DIA
(20MM. DIA)
(HOLE)
FIG. 5
Nut Plate
.312 IN DIA
(9MM. DIA)
(2 PLACES)
1.378 IN DIA
(35MM. DIA)
2.362 IN DIA
(60MM. DIA)
FIG. 2
M10
BOLT
FIG. 6
Silicone Pad Support Block
FIG. 3
M4
SCREWS
FIG. 7
Page: 5
REV: 06/02/21
M-Series