Steelcase west elm Greenpoint Benching Instructions De Montage page 4

®
SAMPLE CONFIGURATION
Dual Sided 6-Pack
Follow steps on page 1 to
assemble boat brace to all worksurfaces.
Follow steps on page 4
to assemble power options and tray clips.
Follow steps on page 1 to
assemble end leg to 2 worksurfaces.
Follow steps on page
to assemble intermediate leg to
same 2 worksurfaces.
Assemble intermediate leg to
two additional worksurfaces.
Flip worksurface and align to
brackets on previous intermediate leg (6a)
and install using 12 screws. Install tie brackets. (6b)
Assemble end leg to two additional
worksurfaces and repeat steps 6a and 6b to install
worksurface and tie brackets.
Follow steps on page 2
to assemble upmount bins.
9.
Follow steps to assemble power trays (pg 4 ),
extension trays (pg 4 ), modesty panels (pg 25),
and end covers (pg ).
NOTE: Sample configuration shown
to demonstrate order of install.
2x
Page 4 of 53
Doc # 142344 Rev F