Steelcase west elm Greenpoint Benching Instructions De Montage page 37

®
Assembly for New York Power-In Feed
1.
Assemble junction box, without cover.
NOTE: Determine which end of the desk
frame the box will be mounted. Electrician to
remove knockouts prior to mounting junction
box.
The modular/hardwire harness provided is
supplied for a maximum length desk and will
need to be cut to length for shorter desks.
desired.
2.
Measure length from the junction box to the
modular connector (plan junction box distance
mounted 6" from cantilever. See page 8).
Remove conduit connector before cutting modular/
hardwire harness to length (2a). Reattach conduit
connector, tighten nut, and secure to junction box.
Route modular/hardwire harness through knockout
with electrician's power supply cable. Electrician to
connect power source wires to the modular/hardwire
harness with wire nuts (2b). Place connected power
inside junction box and fasten junction box cover (2c).
NOTE: If nuts cannot be tightened, remove item 1A,
tighten and reattach.
Harness route and trim may be completed after
mounting junction box if desired.
JUNCTION BOX
COVER
WIRE NUT
CONDUIT
CONNECTOR
ELECTRICIAN
SUPPLIED
Doc # 142344 Rev F
Page 37 of 53