Assembly Instructions; Operating Your Smoker; Select A Proper Location; Special Instructions For The Use Of Regulator And Cylinder - Cuisinart COS-244 Mode D'emploi

4. Assembly Instructions (cont.)
Step 13:
Connect the match holder to the
smoker body using screw (FF).
10
Step 12:
Use screws (AA) to secure the
hook on the front right leg.
Then put the gas hose on it.

5. Operating Your Smoker

5.1 Select a Proper Location

Note: The use and installation of this product must conform to local codes. In absence of local codes, use the National
Gas and Propane Installation Code, CSA B149.1; Propane Storage and Handling, CSA B149.2 .
DANGER
1. Never use this outdoor smoker inside any building, garage, shed or breezeway, or inside any boat, trailer or recre -
asphyxiation.
2. Always place your smoker on a hard and level surface far away from combustible materials and structures.
3. Do not use this smoker under an overhead combustible surface or
covered area ( e.g., awnings, umbrellas, porches or gazeboes ). Keep
all combustible surfaces at least 3ft(91cm) away.
4. Locate the smoker away from any combustible and non-combustible
material or construction by at least 3ft(91cm) from back and 3ft
(91cm) from side.(See the diagram below)
5.
in the vicinity of this smoker or in the vicinity of any other heat-
6. The cylinders can be disconnected when the appliance is not in use.
5.2 Special Instructions for the Use of Regulator and Propane Cylinder
GAS HOOK-UP Only the pressure regulator and hose assembly supplied with the smoker should be used. Any
LIQUID PROPANE CYLINDER REQUIREMENTS: (20-lb Cylinder) A dented or rusty Liquid Propane cylinder may be
hazardous and should be checked by your supplier. Never use a cylinder with a damaged valve. The Liquid Propane
United States Department of Transportation (DOT) or the National Standard of Canada, CAN/CSA -B339, Cylinders,
Spheres and Tubes for Transportation of Dangerous Goods Commission. The 20-lb cylinder must have a shut off valve
cylinder valve outlet and inlet connection ANSI/CGA-V-1. Storage of an outdoor cooking gas appliance indoor is
permissible only if the cylinder is disconnected and removed from the outdoor cooking gas appliance. The cylinder
system must be arranged for vapor withdrawal. The cylinder must include a collar to protect the cylinder valve. Manifold
pressure: (operating) 11 inches water column (W.C.), (non-operating) 11.2 inches water column (W.C.). The Liquid
Liquid Propane cylinder is placed into the cart.
CONNECTING THE LIQUID PROPANE CYLINDER: To connect the Liquid Propane gas supply cylinder: The cylinder
valve should be in the "OFF" position. If not, turn the valve clockwise until it stops. Make sure the cylinder valve has
the proper type-1 external male thread connections per ANSI Z21.81. Make sure the burner valves are in the "OFF" p-osi
tion. Inspect the valve connections, port and regulator assembly. Remove debris and inspect the hose for damage. When
connecting the regulator assembly to the valve, use your hand to tighten the nut clockwise until it stops. Use of a wrench
could damage the quick coupling nut and result in a hazardous situation Open the cylinder valve fully by turning the valve
counterclockwise. Before lighting the smoker, use a soap and water solution to check all the connections for leaks. If a leak
is found, turn the cylinder valve "OFF" and do not use the smoker until a local Liquid Propane dealer can make repa rs.
11