Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
Please note:
Before assembling, first read through all the instructions carefully.
Remove stones and other objects from your work surface to prevent damage.
To avoid damaging the plyo box during assembly, we recommend that you ask a second person to help you.
When assembling, make sure that the sides with writing on face outwards.
Make sure that all parts are flush with each other and that there are no protruding edges.
PREPARATION
Unpack all parts and lay them out clearly on the floor.
First, check the condition and completeness of all parts. Never use parts that have already been dam-
aged. Contact us if parts are damaged or missing.
Use an electric screwdriver for assembly.
To increase the stability of the box, you can also glue the parts together with a colourless wood glue
before screwing them together.
❸
Line up a 60 cm panel ❸ and a 50 cm
panel ❹ and screw them together. Do not
fully tighten the screws yet.
❻
❼
Put the middle ❻ and long supports ❼
together and place the short support ❺
on the long support ❼. Screw the short
❺ and long supports ❼ together so that
all parts stay fixed together.
Sport-Tec GmbH ∙ Physio & Fitness ∙ www.sport-tec.de
❹
Repeat the first step and join the two
parts together. Make sure the handles are
facing up. Only loosely fasten the screws
at first.
❺
Place the supports in the middle of the
box. This stabilises all the outer panels.
❷
Place a 75 cm panel ❷ on the parts that
have already been screwed together and
screw everything together lightly.
❷
Close the box with the last panel ❷ and
screw them together. Now tighten all
screws properly.
11
Publicité
