Jenn-Air PRO-STYLE JGD8348CDP Guide De L'utilisateur page 6

Masquer les pouces Voir aussi pour PRO-STYLE JGD8348CDP:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

U
Y
SING
OUR
C
L
ONTROL
OCATIONS
1
2
1. Left rear surface burner or grill.
2. Left front surface burner or grill.
3. Center rear surface burner.
4. Center front surface burner.
5. Right rear surface burner.
6. Right front surface burner.
NOTES:
A properly adjusted burner with clean ports will light within a few seconds. If using
natural gas, the flame will be blue with a deeper blue inner cone.
If the burner flame is yellow or is noisy, the air/gas mixture may be incorrect. Contact
a service technician to adjust. (Adjustments are not covered by the warranty.)
With LP gas, some yellow tips on the flames are acceptable. This is normal and
adjustment is not necessary.
With some types of gas, you may hear a "popping" sound when the surface burner
is turned off. This is a normal operating sound of the burner.
If the control knob is turned very quickly from hi to lo, the flame may go out,
particularly if the burner is cold. If this occurs, turn the knob to the OFF position,
wait several seconds and relight the burner.
• Leave a minimum of 1
countertop, back splashes or side walls, to allow heat to escape and avoid possible
damage to these areas.
To improve cooking efficiency and to prevent possible damage to the cooktop or pan,
the flame must be adjusted so it does not extend beyond the edge of the pan.
C
OOKTOP
Fan
3
4
NOTE: When using a JGA8100 surface
burner assembly with control locations #1
and #2, the control knob may be turned to
a position lower than the Lo setting. (The
Lo setting is set for the grill burner.)
1
/
" between side of pan and surrounding surfaces such as
2
,
.
CONT
5
6
5
C
OOKTOP
To prevent the cooktop from discol-
oring or staining:
Clean cooktop after each use.
Wipe acidic or sugary spills as soon
as the cooktop has cooled as these
spills may discolor the porcelain.
S
B
EALED
URNERS
The sealed burners of your cooktop are
secured to the cooktop and are not de-
signed to be removed. Since the burners
are sealed into the cooktop, boilovers or
spills will not seep underneath the cooktop.
However, the burner heads should be
cleaned after each use. (See page 9 for
cleaning directions.)
B
G
URNER
RATES
The grates must be properly positioned
before cooking. Improper installation of
the grates may result in chipping of the
cooktop.
Do not operate the burners without a
pan on the grate. The grate's porce-
lain finish may chip without a pan to
absorb the heat from the burner flame.
Although the burner grates are durable,
they will gradually lose their shine and/or
discolor, due to the high temperatures of
the gas flame.

Publicité

Table des Matières
loading

Table des Matières