PULOX PO-200A Mode D'emploi page 25

Set limit values for details.
Exit: Briefly press the button to select "Exit", then long press the
button to exit the alarm menu and return to the main menu.
c. Set limit values
Dir: When you enter the limit value settings, „Dir" is already selected.
Long press the button to switch between up (increase the value) and
down (decrease the value).
High: Briefly press the button to select "High". Long press the button
to set the upper limit prompt of pulse or SpO
direction in which you want to change the value is correctly set to up
or down. Lower limit can not exceed the upper limit.
Low: Briefly press the button to select "Low". Long press the button to
set the lower limit prompt of pulse or SpO
direction in which you want to change the value is correctly set to up
or down. Lower limit can not exceed the upper limit.
Exit: Briefly press the button to select "Exit", then long press the
button to exit and return to the alarm menu.
8. Cleaning, Transportation and Storage
 Please change the batteries when the low-voltage is being
displayed on the screen.
 Please clean the surface of the device before using. Wipe the
device with medical alcohol first, and then let it dry on air or clean
it with dry clean fabric.
 Using the medical alcohol to disinfect the product after use,
prevent from cross infection for next time use.
 Please take out the batteries if the oximeter is not in use for a long
time.
 The best storage environment of the device is -40ºC to 60ºC
ambient temperature and not higher than 95% relative humidity.
High-pressure sterilization cannot be used on the device.
Do not immerse the device in liquid.
It is recommended that the device should be kept in a dry
environment. Humidity may reduce the useful life of the device,
or even damage it.
→ Direction: up, down
→ Upper limit prompt
→ Lower limit prompt
Make sure that the
2.
Make sure that the
2.
EN