View Of The Front Panel - PULOX PO-200A Mode D'emploi

6. Installation

6.1 View of the front panel

Fig. 2 Front view
6.2 Battery
Step 1. Refer to Figure 3 and insert the two AAA size batteries properly
in the right direction.
Step 2. Replace the cover.
Please take care when you insert the batteries for the improper
insertion may damage the device.
6.3 Mounting the Hanging Rope
Step 1. Put the end of the rope through
the hole.
Step 2. Put another end of the rope
through the first one and then tighten it.
7. Operating Guide
A. Measurement
1) Insert the two batteries properly in the correct direction and then
replace the cover.
2) Open the clip as shown in Figure 4.
3) Put the patient's finger into the rubber cushions of the clip (make
sure the finger is in the right position), and then clip the finger.
4) Press the switch button once on front panel.
5) Do not shake the finger and keep the patient at ease during the
process. Meanwhile, human body is not recommended in
movement status.
6) Get the information directly from screen display.
Figure 4 Finger Position
Fig. 3 Batteries installation
EN