PULOX PO-200A Mode D'emploi page 24

7) The button
off, press the button to turn it on. When the device is on, press the
button shortly to enter the menu. In the state of alarm, press the
button long to pause the alarm for 60s.
B. Change display direction:
The display direction of the screen changes automatically.
C. Pause sound prompt
1. Sound prompt includes over-limit prompt or finger out prompt.
2. In sound prompt "ON" state, when the sound prompt occurs, short
press the button to pause the sound prompt, and it will resume
automatically after about 60s.
3. If you want to turn off the sound prompt permanently, please set it
in menu.
D. Menu operation
a. Main menu
Pulse: When you enter the main menu, „Pulse" is already selected.
Press the button for a few seconds to turn on the pulse sound. Long
press again to switch off the pulse sound. Press the button long to turn
the pulse sound on. Long press again to switch off the pulse sound.
Alarm: Press the button briefly to select „Alarm". Press the button for
a few seconds to turn on the alarm prompt on. Long press again to
switch off the alarm prompt.
Alarm Set: Press the button briefly to select „Alarm Set". Press the
button for a few seconds to go into the sound prompt menu. For
details on setting the limit values, see c. Set limit values.
Exit: Short press the button to select "Exit", then long press the button
to exit the main menu and return to the measurement interface.
b. Sound prompt menu
Pulse Alarm: Press the button briefly to select „Pulse Alarm". Press the
button for a few seconds to go to the Pulse limit value settings, see c.
Set limit values for details.
SpO Alarm: Press the button briefly to select „ SpO
2
button for a few seconds to go to the SpO2 limit value settings, see c.
has three functions. When the device is
→ Pulse Sound on / off
→ Alarm on / off
→ Sound prompt menu
→ Exit main menu
→ Set Pulse Limits
→ Set SpO2 Limits
→ Exit Sound Prompt menu
Alarm". Press the
2
EN