Makita DUB184 Manuel D'instructions page 9

OPERATION
CAUTION:
Do not place the machine on the
ground hile it is s itched on. Sand or dust may
enter from suction inlet and cause a malfunction or
personal injury.
Hold the machine firmly with a hand and perform the
blowing operation by moving it around slowly. When
blowing around building, big stone or vehicle, direct the
nozzle away from them. When performing an operation
in a corner, start from the corner and then move to wide
area.
Ƌ Fig.12
MAINTENANCE
CAUTION:
Al ays be sure that the machine is
s itched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
TROUBLESHOOTING
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the man-
ual, do not attempt to dismantle the machine. Instead, ask Makita Authorized Service Centers, always using Makita
replacement parts for repairs.
State of abnormality
Motor does not run.
Motor stops running after a little use.
The machine does not reach the
maximum speed.
Abnormal vibration:
stop the machine immediately
Motor cannot stop:
Remove the battery immediately
Probable cause (malfunction)
Battery cartridge is not installed.
Battery problem (under voltage)
The drive system does not work
correctly.
Battery s charge level is low.
Overheating.
Battery is installed improperly.
Battery power is dropping.
The drive system does not work
correctly.
The drive system does not work
correctly.
Electric or electronic malfunction.
9 ENGLISH
Cleaning the machine
Clean the machine by wiping off dust with a dry cloth or
one dipped in soapy water and wrung out.
Ƌ Fig.13
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Remove dust or dirt from the suction inlet at the rear of
the machine.
Ƌ Fig.14: 1. Suction inlet
Storage
The hook hole on the bottom of the machine is conve-
nient for hanging the machine from a nail or screw on
the wall. Store the machine in a place out of the reach
of children and not exposed to moisture or rain.
Ƌ Fig.15: 1. Hole
Remedy
Install the battery cartridge.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Recharge the battery. If recharging is not effective,
replace battery.
Stop using the machine to allow it to cool down.
Install the battery cartridge as described in this
manual.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Ask your local authorized service center for repair.
Remove the battery and ask your local authorized
service center for repair.