Table des Matières
Publicité
(c) respectent les exigences de traçabilité prévues à l'article 17 du règlement (CE) n° 1935/2004 ;
(d) sont fabriqués conformément aux bonnes pratiques de fabrication telles que définies dans le règlement (CE) n°
2023/2006 de la Commission ; et
(e) respectent les exigences en matière de déclaration et de composition énoncées aux chapitres II, III et IV du présent
règlement.
Les matériaux d'impression et les cartouches destinés à entrer en contact avec des denrées alimentaires ont été soumis
à des tests de migration globale et se sont révélés conformes aux limites fixées à l'article 12, paragraphe 1, du règlement
(UE) n° 10/2011.
ARTICLE 12
Limite de la migration mondiale
1. Les matériaux et objets en plastique ne doivent pas transférer leurs constituants aux simulants d'aliments dans des
quantités supérieures à 10 mg de constituants totaux libérés par dm2 de surface en contact avec les aliments (mg/dm2).
To all customers using Modecor food printers
Food printers, as an equipment whose components (drive rollers in particular) come into contact with edible products
(wafer sheets, sugar paste, etc.), and cartridges containing food inks, have been subjected to laboratory tests to guarantee
consumer safety in terms of migration of the components to food.
There is no specific European legislation for food printers or cartridges, but there are European regulations concerning
food contact machines and food contact materials that must be complied with.
Modecor, in order to prevent any controversy with control organs and for the protection of the consumer, has always
adapted and respected the following regulations that for your knowledge we recall below:
DIRECTIVE 2006/42/CE - MACHINERY DIRECTIVE -
ART. 21.1 FOOD MACHINERY AND MACHINERY FOR COSMETIC OR PHARMACEUTICAL PRODUCTS
General considerations
Machinery intended for use with edible products, or cosmetic or pharmaceutical products must be designed and
constructed to avoid any risk of infection, sickness, or contamination.
Art. 1.7.3 Marking of machinery
Each machine must bear, legibly and indelibly, at least the following particulars
•
name of manufacturer
•
the CE marking
•
designation of series or type
•
where appropriate, the serial number
(**) Framework Regulation 1935/2004 MATERIALS AND OBJECTS INTENDED TO COMBAT FOOD PRODUCTS
ARTICLE 3 (EC Regulation 1935/2004)
General requirements
1. Materials and articles, including active and intelligent materials and articles, shall be manufactured in compliance with
good manufacturing practice so that, under normal or foreseeable conditions of use, they do not transfer their
constituents to food in quantities which could:
(a) constitute a danger to human health;
(b) bring about an unacceptable change in the composition of the edible product; or
(b) bring about an unacceptable change in the composition of the food;
or
(b) bring about an unacceptable change in the composition of the food; or organoleptic characteristics.
2. The labelling, advertising and presentation of a material or article shall not mislead consumers.
elite
Decojet A3
55
Publicité
Table des Matières
