Zipper Maschinen ZI-WP400TN Mode D'emploi page 32

ZIPPER MASCHINEN GmbH
ZI-WP400TN
www.Zipper-Maschinen.at
7. Assembly saw blade
CAUTION
When handling circular saw blades
when changing tools, please use
safety gloves to avoid risk of injury.
Slide the rear saw blade flange onto the motor
shaft.
CAUTION
Make sure that the saw blade is
inserted in the correct position. The
arrow on the saw blade must point in
the direction of the operating side!
Place the saw blade together with the front
clamping flange on the rear flange and secure it
with the nut M20×1.5 as shown in Fig. G, Pic. 1.
Tighten the nut with the saw blade wrench by
holding the front clamping flange with the face
wrench in order to stop back as shown in Fig. G,
Pic. 2 & 3.
NOTICE
Please note! Always keep the two
special keys properly.
8. Assembly outer saw blade cover
Fix the outer saw blade cover to the inner cover
using four M5×10 cross-head screws and washers
as shown in Fig. H.
ASSEMBLY
32