Samsung NE59J7650 Serie Manuel D'utilisation page 51

DRAWER
Problem Possible cause
The Drawer The drawer is out of
does not slide alignment.
smoothly or
The drawer is over-
drags.
loaded or the load is
unbalanced.
The Warming A fuse in your home
drawer will not may be blown or circuit
work. breaker tripped.
The controls are not set
correctly.
Excessive There is liquid present in
condensation the drawer.
in the drawer.
Uncovered foods.
The temperature is set
too high.
Food dries out Moisture is escaping.
in the warming
The drawer is not fully
drawer.
closed.
Solution
Fully extend the drawer and push it
all the way in. See the page 45.
Reduce weight. Redistribute drawer
contents.
Replace the fuse or reset the circuit
breaker.
See the chapter on using the
warming drawer on pages 37-38.
Remove the liquid.
Cover food with a lid.
Adjust the temperature to a lower
setting.
Cover food with a lid.
Push the drawer in until the latch
engages.
Information codes
OVEN
Displayed Code Possible cause
C-20 The oven sensor is
open when the oven is
operating.
The oven sensor is
short when the oven is
operating.
C-21 This code occurs if the
internal temperature
rises abnormally high.
C-d1 This code occurs
if the door lock is
mispositioned.
C-d0 This code occurs if the
Control key is short for
1 minute.
C-30 The PCB sensor is
open when the oven is
operating.
The PCB sensor is
short when the oven is
operating.
C-31 This code occurs if the
PCB temperature rises
abnormally high.
Solution
Press OVEN OFF and restart the
oven. If the problem persists,
disconnect all power to the range
for at least 30 seconds and then
reconnect the power. If this does
not solve the problem, call for
service.
Press OVEN OFF and restart the
oven. If the problem persists,
disconnect all power to the range
for at least 30 seconds and then
reconnect the power. If this does
not solve the problem, call for
service.
Call for service.
English 51