3M Peltor ComTac VI NIB MT20H682 N Serie Mode D'emploi page 21

EN
2.5 Attach the boom microphone arm guide on the headband by rotating the arm guide and align it so it fits with relative ease as
shown in figure 2.5-a and 2.5-b. NOTE: Make sure you rotate the boom microphone earcup arm guide as shown in the figures,
because of the earcup arm guide lock when positioned in place.
(2.5-a)
2.6 Install the headband with the boom microphone earcup arm guide on the left earcup. First rotate the left cup to install the earcup
arm guide as shown in figure 2.6.-a and 2.6-b. Force will be required. NOTE: The boom microphone earcup arm guide should be
installed mirrored to the other earcup arm guides to avoid conflict with the boom microphone connector jack.
(2.6-a)
2.7 Rotate the boom microphone earcup arm guide in position, and install the boom microphone connector to the earcup connector
jack on the left earcup as shown in figure 2.7-a and 2.7-b.
(2.7-a) (2.7-a)
(2.5-b)
(2.6-b) (2.6-b)
(2.7-b) (2.7-b)
15