3M Peltor ComTac VI NIB MT20H682 N Serie Mode D'emploi page 24

2.10 Run the headband cable in the rubber band groove and close the rubber band as shown in figure 2.10-a by clipping the rubber
band ridges in figure 2.10-b.
(2.10-a)
2.11 Continue to clip all ridges (figure 2.11-a), while making sure the cable is bedded in the plastic groove shown in figure 2.11-b.
Make sure all the ridges are clipped, the cable is fully bedded in the groove, and cable loops are made on both sides of the headband
to allow stress relief as seen in figure 2.11-c.
(2.11-a)
Push cable in
rubber groove
(2.10-b)
Clip/Close rubber ridges
(2.11-b)
18
EN