5. Preparation
5.1 Inserting the batteries
• Remove the battery cover from
the back of the monitor. Insert
four AA 1.5 V alkaline batteries.
making absolutely sure that
you insert them with the correct
polarity as marked. Never use
rechargeable batteries.
• Replace the battery cover care-
fully. Now you can set the date
and time.
5.2 Setting the date and time
• First the year starts blinking. Press M1 to increase numbers, or M2 to de-
crease. Set the year accordingly and confirm with the Start/Stop button.
• Using the M1 and M2 buttons, now enter the month. Confirm with the Start/
Stop button.
• Now enter the day using the M1 and M2 buttons. Confirm with the Start/
Stop button.
• Now you can set the time. This is displayed in 24-hour mode. First enter the
hours, confirm with the Start/Stop button and then enter the minutes. Once
this is confirmed using the Start/Stop button, the device automatically re-
turns to normal time mode.
5.3 changing batteries
If the battery change
though measurement is still possible, the batteries should be replaced soon. If
the battery change
possible and you must replace all the batteries. Once batteries have been re-
moved from the device, the time must be reset. Any measurement results that
have been stored are however retained.
Used batteries do not belong in the household waste. You are
legally obliged to dispose of the batteries. Dispose of them via
your specialist electrical supplier or local collecting point for re-
cyclable waste. Note: Batteries containing pollutant substances
are marked as follows: Pb = Battery contains lead, Cd = Battery
contains cadmium, Hg = Battery contains mercury.
The battery contained in this instrument is pollutant-free.
Please dispose of the device in accordance with the directive 2002/96/EG
– WEEE (Waste Electrical and Electronic Equipment). If you have any que-
ries, please refer to the local authorities responsible for waste disposal.
5.4 Mains operation
You can also operate this device with a mains adapter. No batteries should
be in the battery compartment for this. The mains adapter is available from
retailers or from the service address under order no. 071.01. The blood pres-
is blinking, the batteries are already too low. Even
is continuously illuminated, measurement is no longer
13
4 x AA (LR6) 1,5 V