Publicité
Les langues disponibles
Les langues disponibles
Installation
Installation
NOTICE!
Avoid cleaners containing organic solvents,
alcohols, and hydrocarbons. Rinse with water
after cleaning.
Supplies Required:
• Teflon tape and/or pipe sealant
• ½" NPT water supply inlet (30–90 psi)
• (2) ¼-20 screws (stainless steel recommended)
and anchors
• Backflow prevention device as required by UPC,
IPC and/or local plumbing codes
Local codes may require the installation of a backflow
prevention valve to complete proper installation.
Compliance with local codes is the responsibility of the
installer. Valve must be tested annually to verify that it
is functioning properly. Backflow prevention valves are
not included with the fixture and may be supplied by the
contractor or purchased from Bradley Corporation.
Step 1: Mount the bracket to the wall
1. Rough in ½" NPT supply piping (by installer) from the
wall where the drench hose is desired.
2. Using the bracket flange as a template, mark the
anchor/screw locations on the wall.
3. Mount the bracket to the wall with two suitable anchors
and ¼-20 screws (supplied by installer).
Step 2: Connect the hose assembly
Apply pipe sealant (supplied by installer) to all male
threaded pipe joints.
1. Connect rigid end of the drench hose to the ½" NPT
elbow.
2. Connect the ½" NPT elbow (provided) to the ½" NPT
supply from the wall.
3. Install the valve body onto the swivel end of the hose.
4. Open the water supply line. Test for leaks and adequate
water flow.
Bradley • 215-1691 Rev. D; ECN 14-05-013
S1944011CBC, S1944011CBD
Wall
9"
(229mm)
7-1/2"
(191mm)
5-1/2"
(140mm)
6-3/4"
(171mm)
7/29/2014
3
Publicité
