Orbegozo CP 99132 Manuel D'instructions page 16

CP 99132
INSTALLING THE REMOTE CONTROL
RECEIVER
OPERATING THE FAN
- Select the fan speed by pressing the speed control button on the remote control transmitter :
HI: High Speed MED : Medium Speed LOW : Low Speed OFF : Off
- Cold weather: Push the switch 'UP' so that the blades will bring the warm air trapped near the
ceiling fan to move downwards throughout the room.
- Hot weather: Push switch 'DOWN' so that the blades will create a breeze and circulate the air
to the room.
- Pressing the 'ON/OFF' light button on the remote control transmitter can control the turning
on or off of the light.
REMOTE CONTROL
- Use the remote control transmitter to change the speed of the fan and to switch the light
and fan on or off.
- Replace the batteries by sliding the battery compartment cover on the remote control
transmitter in the direction of the arrow, fit 1 x A23 12v battery
(Note : Batteries NOT included).Re-assemble the battery compartment cover.
- Always ensure the battery compartment cover is closed properly.
- Don't expose the remote control to direct sunlight.
- Don't attempt to recharge expired batteries. There are special rechargeable batteries,
which are clearly marked with.
- Don't dispose of batteries in fire to avoid explosion.
REMOTE CONTROLLER OPERATION:
Point the remote at the infrared sensor to power the fan.
16