Assembly - Husqvarna PAB1100 Manuel D'utilisation

Safety instructions for the cutting equipment
WARNING: Read the warning instructions
that follow before you use the product.
• Only use the guide bar/saw chain combinations and
filing equipment that we recommend. Refer to
Maintenance on page 9 for instructions.
• Use protective gloves when you use or do
maintenance on the saw chain. A saw chain that
does not move can also cause injuries.
• Keep the cutting teeth correctly sharpened. Obey the
instructions and use the recommended file gauge. A
saw chain that is damaged or incorrectly sharpened
increases the risk of accidents.
• Keep the correct depth gauge setting. Obey the
instructions and use the recommended depth gauge
setting. Too large depth gauge setting increases the
risk of kickback.
Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.
To assemble the cutting head
CAUTION: Make sure that the drive shaft
inside the shaft engages with the cut-out in
the cutting head.
B
6
•
•
SAVE THESE
INSTRUCTIONS

Assembly

1. Loosen the screw on the cutting head. (A)
2. Fit the cutting head on the shaft so that the screw (A)
3. Screw in screw A finger tight. Make sure that screw
4. Tighten screw A.
5. Tighten screw B.
To assemble the bar and chain
1. Unscrew the bar nut and remove the protective
2. Fit the bar over the bar bolt. Place the bar in its
A
Make sure that the saw chain has the correct
tension. If the saw chain is not tight against the guide
bar, the saw chain can derail. An incorrect saw chain
tension increases wear on the guide bar, saw chain
and chain drive sprocket. Refer to
chain on page 13 .
Do maintenance on the cutting equipment regularly
and keep it correctly lubricated. If the saw chain is
not correctly lubricated, the risk of wear on the guide
bar, saw chain and chain drive sprocket increases.
is aligned with the hole in the shaft as shown.
A fits into the hole in the shaft.
cover.
rearmost position. Place the chain over the drive
sprocket and in the groove on the bar. Begin on the
top side of the bar.
To tension the
1358 - 001 - 18.10.2019