Evaluating Results - Beurer medical BM 65 Mode D'emploi

no button is pressed, the most recently used user memo-
ry is automatically used after 5 seconds.
ly displayed. If there is no measurement in the memory,
the instrument always displays the value "0".
released slowly.
If a tendency towards high blood pressure is already
detectable, the cuff is pumped up again and cuff pressure
increased further. As soon as a heart rate is detected, the
heart beat symbol is displayed.
played.
"START/STOP" button.
measurement properly. Observe the section in these in-
structions on error messages/troubleshooting and repeat
the measurement.
forget to turn off the device, it will switch off automatically
after approx. 1 minute.
Wait at least 5 minutes before taking another measurement!

6. evaluating results

Cardiac arrhythmia:
-
This instrument can identify possible cardiac arrhythmia dis-
orders during measurement and if necessary indicates the
measurement with the flashing icon
This may be an indicator for arrhythmia. Arrhythmia is a
condition where the heart rhythm is abnormal as a result of
defects in the bioelectrical system controlling the heart beat.
The symptoms (omitted or premature heart beats, slow or
excessively fast heart rate) may be caused, among other
things, by heart disease, age, physical predisposition, ex-
-
cessive use of stimulants, stress or lack of sleep. Arrhythmia
can only be ascertained through examination by your doctor.
Repeat the measurement if the flashing icon
played after the measurement. Please note that you should
rest for 5 minutes between measurements and not talk or
move during the measurement. If the icon
often, please contact your doctor. Any self-diagnosis and
treatment based on the test results may be dangerous. It is
vital to follow your doctor's instructions.
19
.
is dis-
appears