Electrolux IK257SZR Notice D'utilisation page 80

23.
23.
Screw the bottom of the door onto the door panel (4 x 15 screws).
24.
Undo the angle bracket screws on
the underside of the door.
Adjust the depth of the panel.
Tighten the screws.
Fit the cover to the outer angle
bracket.
Note
Do not fit a cover to the inner angle
bracket. This is the area where the
soft stop mechanism is located.
Important
Align external door panels so that
there is a gap of approx. 2 mm be-
tween the door panel and the body
of the unit.
This will ensure that the door seal
closes properly.
25.
Schließdämpfer auseinanderziehen, auf
den Kugelbolzen drücken und einrasten.
80
26.
Insert the angle brackets
behind the retaining plates and
secure using two 3.5 x 11 screws per
bracket.
Important
Slide the angle bracket to the left, then tighten the
screws.
24.
The angle bracket must be in contact with the
retaining plate.
25.
26.
27.
27.
Fit cover caps.
26.
27.