14.
Screw the angle brackets onto the underside of the door using
4 x 15 screws.
Push the bracket to the back as far
as it will go, then tighten the screw.
15.
Place the door panel on the adjusting screws and align in the centre.
Screw the nuts onto the adjusting screws and tighten.
To do so, use the ring spanner provided.
15.
16.
Close the door and check the position
of the door panel.
Aligning the door panel
17.
17.
Undo the nuts.
18.
Align the door panel vertically by
turning the adjusting screws.
Use a Torx 15 screwdriver (not supplied in the
accessory pack).
19.
Align the door horizontally.
20.
Tighten the nuts.
21.
Undo the screws.
22.
16.
Adjust the depth of the door panel.
Tighten the screws.
17.
20.
20.
22.
21.
21.
GB
18.
19.
79