Power Save - Datalogic Heron D130 Guide Rapide

RS232 Nixdorf DEFAULT SETTINGS
9600 baud, parity odd, 8 data bits, 1 stop bit, handshaking
hardware (RTS/CTS), delay disabled, rx timeout 9,9 sec.,
ack/nack disabled, FIFO disabled, serial trigger lock disabled.
DATA FORMAT
code length not transmitted, no header, terminator = CR,
character replacement disabled.
RS232 Fujitsu DEFAULT SETTINGS
9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking,
delay disabled, rx timeout 2 sec., ack/nack disabled, FIFO
enabled, serial trigger lock disabled.
DATA FORMAT
code length not transmitted, no header, terminator = CR,
character replacement disabled.
RS232 ICL DEFAULT SETTINGS
9600 baud, parity even, 8 data bits, 1 stop bit, handshaking
RTS always on, delay disabled, rx timeout 9,9 sec., ack/nack
disabled, FIFO enabled, serial trigger lock disabled.
DATA FORMAT
code length not transmitted, no header, terminator = CR,
character replacement disabled.
WEDGE DEFAULT SETTINGS
USA keyboard, caps lock off, caps lock auto-recognition
enabled, num lock unchanged, inter-character and inter-
code delays disabled, control character emulation =
ctrl+shift+key.
DATA FORMAT
code length not transmitted, no header, terminator =
ENTER, character replacement disable.
PEN EMULATION DEFAULT SETTINGS
interpret mode, conversion to code 39 disabled, output level
normal, idle level normal, minimum output pulse 600 µs,
overflow medium, inter-block delay disabled.

POWER SAVE

scan rate max, standby disabled, sleep/USB suspended
disabled.
READING PARAMETERS
hardware trigger, trigger active level, no trigger timeout,
Flash On = 1 sec, Flash Off = 0,6 sec, one read per cycle,
safety time 0,5 sec, beeper intensity high, tone 2, beeper
type monotone, beeper length short, good read spot
duration medium,
automatic operation aiming light enabled.
: code identifier enabled, no field adjustment,
: code identifier enabled, no field adjustment,
: code identifier enabled, no field adjustment,
: code identifier disabled, no field adjustment,
stand recognition beep enabled;