Configuration De L'emulation Crayon - Datalogic Heron D130 Guide Rapide

CONFIGURATION DE L'EMULATION CRAYON

Lire le code de configuration par défaut puis le code de
configuration PEN.
CONFIGURATION PAR DEFAUT
USB DEFAULT SETTINGS
DATA FORMAT
code length not transmitted, character replacement disabled.
USB KEYBOARD
code delays disabled, control character emulation =
ctrl+shift+key;
: no handshaking, delay disabled, rx timeout 5 sec.,
USB COM
ack/nack disabled, FIFO enabled, serial trigger lock disabled;
Default Headers and Terminators for each USB mode:
-
USB-KBD: no header, terminator = ENTER
-
USB-KBD-ALT-MODE: no header, terminator = CR
-
USB-COM: no header, terminator = CR-LF
-
USB-IBM-TABLE TOP: not applicable
-
USB-IBM-HAND HELD: not applicable
RS232 Standard DEFAULT SETTINGS
9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking,
delay disabled, rx timeout 5 sec., ack/nack disabled, FIFO
enabled, serial trigger lock disabled;
DATA FORMAT
code length not transmitted, no header, terminator = CR-LF,
character replacement disabled
CONFIGURATION PAR DEFAUT
Ì$+$*oÎ
Ì$+CP6$-BÎ
: code identifier disabled, no field adjustment,
: USA keyboard, inter-character and inter-
: code identifier disabled, no field adjustment,
PEN