Airwell XDA Mode D'emploi page 8

SETTING THE TIMER
EN
A) HOW TO SET THE ON TIMER
1. In the standby state, press the
TIMER button once to enter the
timed power-on setting state:
the symbol
2. Press the + button (or - button) to
adjust the set time value (range 0.5-
24 hours), each time you press the
+ button (or -Key), the time value
increases (or decreases) by 0.5
hours.
After adjusting the time value, press
the timer button again to confirm and
enter the timed state:
the symbol
on the display the remaining time of
the power on.
B) HOW TO SET THE OFF TIMER
1. In the power-on state, press the
timer button once to enter the timer
shutdown setting state:
the symbol
2. Press the + key (or - key) to adjust the
set time value (range 0.5-24 hours).
Each time you press the + key (or
- key), the time value increases (or
decreases) by 0.5 hours.
After adjusting the time value, press
the timer button again to confirm and
enter the timed shutdown state:
the symbol
on the display the remaining time of
shutdown.
ADJUSTING THE AIR FLOW DIRECTION
Make sure that the remote control unit has been turned on.
Press the button
CAUTION
Do not move the flap with your hands when the air
conditioner is running.
Sweep function
The flap starts moving up and down to deliver air
over the sweep range.
NOTES
• The flap automatically closes when the unit is off.
• During the heating operation, the fan speed will be very
low and the flap will be in the horizontal position until the
air being blown out of the unit begins to warm. Once the
air warms up, the flap position and fan speed change to
the settings specified with the remote control.
is blinking.
lights. You can see
BLOW
is blinking.
lights. You can see
(FLAP) to select the sweep function.
• Use the FLAP button on the remote control to adjust
the position of the flap. If you move the flap by hand,
the factual flap position and the flap position on the
remote control may no longer match. If this should
happen, shut off the unit, wait for the flap to close,
and then turn on the unit again; the flap position will
now be normal again.
OPERATION WITHOUT THE REMOTE
CONTROL UNIT
If you have lost the remote control unit or it has troubles,
follow the steps below.
1. WHEN THE AIR CONDITIONER IS STOPPED
If you want to turn on the air conditioner push the ON/OFF
BUTTON (with the tip of a pen).
HUMIDITY TIMER
LIGHT
NOTE
The air conditioner will enter the automatic mode
operation: it automatically selects the operating state
according to the indoor temperature (cooling, heating,
air supply), and cannot change the temperature setting
value and fan speed.
2. WHEN THE AIR CONDITIONER IS RUNNING
If you want to turn off the air conditioner push the ON/
OFF BUTTON (with the tip of a pen).
NOTE
Power failure during operation.
In the event of power failure, the unit will stop. When the
power is resumed, the unit must be restarted manually.
8
CAUTION
ON/OFF
button