Télécharger Imprimer la page

Airwell XDA Mode D'emploi page 13

R32
Masquer les pouces Voir aussi pour XDA:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
HOW TO DISCHARGE THE CONDENSATE WATER
The Humidity removed by the unit is collected and
discharged automatically, but in special conditions some
condensate water could remain inside the unit.
If you are not going to make use of the air conditioner for
a long period, it is necessary to discharge the eventual
condensate water through the service cap for condensate
discharge placed under the bottom panel of the unit:
Remove the cap, after having placed a good-sized
container underneath it (at least 5-liter capacity) and
empty the condensate.
Replace the cap.
WARNING
Always switch off the air conditioner before unplugging
it from the power socket.
Always unplug the air conditioner before discharging
the condensate water collected inside.
If the condensate drain system is out of order, the air conditioner display panel
will display "PU "and give an alarm signal.
To enable the air conditioner to work temporarily until the service personnel
arrive, you can drain the water out by following the same procedure.
CARE AND CLEANING
WARNING! For safety's sake, be sure to turn the air conditioner
OFF and also disconnect it from the power supply before cleaning
it.
1. Cleaning of the Air Filter
The air filter must be checked at least once every two weeks
operation. Operation with a dirty filter always causes a lower
efficiency of the air conditioner and severe product damage.
The air filter is located on the top of the unit, under the air
intake grille:
Unhook and manually remove the air intake grille, as
shown in figure.
Remove the two filters from the filter frame.
Use a vacuum cleaner to remove light dust. If there is
sticky dust on the filter, wash them with lukewarm soapy
water, then rinse in clean, cold water and let them dry.
Replace the filters in the filter frame and close the grille.
2. Cleaning of the unit
To clean the air conditioner, wipe it with a clean soft cloth,
lightly moisted. In case it is stained, moisten the cloth with
soapy water. Never use solvents or harsh chemicals, nor very
hot water. Do not pour water over the air conditioner to clean
it: this will damage the internal components and cause an
electric shock hazard.
3. After use
If you are not going to make use of the air conditioner for a long
period, clean the air filter and verify that there is no condensate
water inside the bottom of the unit (see paragraph "HOW TO
DISCHARGE THE CONDENSATE WATER"). Do not put heavy
objects on top of the unit.
4. Transport
Keep the air conditioner in the vertical position during
transportation.
5. For your safety care check periodically the conditions
of the electric supply cable; the electrical connection of
the unit is Y type with cable prepared in a special way; in
case you should notice any damage due to usage, call the
nearest After Sale Service to get the cable replaced.
EN

Publicité

loading