Airwell XDA Mode D'emploi page 14

APP DOWNLOAD AND SETTING UP XDA IN Wi-Fi MODE
1. Install the Airconnect Smart App on your smartphone or tablet by framing the following QR code using a QR code
EN
reader (Alternatively, search and install the Airconnect Smart App in the App store of your smartphone or tablet):
2. Open the Airconnect Smart App.
3. If you don't have an account yet, create one.
4. Accedere all'app con le credenziali del proprio account.
5. Setting up XDA in Wi-Fi mode:
a. Turn on the remote control
b. Set the dehumidification mode with the MODE key
c. Set the temperature to 20° C with the + and - keys
d. Set the timer (HOUR OFF) to 20 in the following way:
• Press the TIME key once to set 20 (HOUR OFF will flash during
the setting)
• Press the + key until you reach 20 (HOUR OFF will flash during
the setting)
• Press the TIME button again to save the setting (HOUR OFF fixed)
e. Press the LIGHT button for 5 consecutive times (light bulb symbol)
ATTENTION: the symbol of the light bulb must appear on the remote control and the LEDs of the unit XDA
must be visible
At this point the Wi-Fi light on XDA starts flashing (see the figure)
f.
MINIMUM REQUIREMENTS FOR SMARTPHONE AND TABLET
With Airconnect Smart App it is possible to manage the main functions of your air conditioner via smartphone and
tablet.
To download and install the App, make sure that your device (smartphone or tablet) has a minimum standard version
of the operating system: version 4.4 or higher for Android, version iOS 9.0 or higher for Apple.
NOTE
For XDA connection to Airconnect Smart App and use of XDA via Airconnect Smart App, see section at the end of
this manual (Wi-Fi GUIDE).
Wi-Fi light
14