Montiss CVH5743M Mode D'emploi page 21

-
It is important to ensure that the dust container is emptied and the filter cleaned regularly. If
it is not done the cleaner will lose its effectiveness. It is best to empty and clean after each
use.
-
Disconnect the cleaner from the supply and separate it from the base section by pressing
the lever.
-
Press the dust container lock button to release the dust container from the vacuum (See Fig.
6).
-
Pull the filter assembly outwards and empty the dust from the container into a waste bin
(See Fig. 7)
-
Unlock the outer microfiber filter by twisting to the right.
-
The HEPA filter should pull away freely from the main casing.
-
The filter should be cleaned every time the dust container is emptied by tapping them on
the side of the dust bin to release any trapped dust.
-
Reassemble in reverse order.
Cleaning the UV-C lamp
-
During use dust will settle on the protection cover which may reduce the effectiveness of
the UV-C light. It is therefore important to clean this periodically.
-
Detach the protection grill on the bottom of the base unit by pulling the 2 clips up with your
thumbs (see picture below).
20