Publicité
Les langues disponibles
Les langues disponibles
V4.0
RAISING AND LOWERING A VEHICLE
Take these additional steps before following instructions in Raising a Load and
Lowering a Load.
1.
Set the vehicle in parking gear and engage the parking brake.
a.
For vehicles with a manual transmission, engage the parking brake
and leave the car in reverse or 1
manual for the correct gear.
2.
Place wheel chocks that fit the wheel curve on either side of the vehicle's
remaining wheels.
3.
Place the jack only on support points or areas specified by the vehicle
manufacturer (consult owner's manual).
4.
Lift the vehicle to a height that leaves enough room to place the jack stands.
5.
When the work is done, raise the load enough with the jack to carefully
remove the jack stands.
6.
Slowly and carefully lower the load.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Keep the tool handles clean, dry and free from oil/grease at all times.
5.
Maintain the tool's labels and name plates. These carry important information.
If unreadable or missing, contact Princess Auto Ltd. for replacements.
6.
Have a qualified technician inspect the jack:
a.
Once a year.
b.
After receiving a shock load. Take the jack out of service until the
technician certifies that it is safe to use.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
Visit www.princessauto.com for more information
4 Ton Low Profile Floor Jack
st
gear. Consult your vehicle owner's
8760621
9
Publicité
