Power Fist 8760621 Manuel De L'utilisateur page 7

V4.0
3. Do not use your hands to detect a fluid leak. Use a large piece of wood,
cardboard or paper and watch for discolouration.
4. Replace damaged parts with identical manufacturer's components to
ensure it is rated to handle the pressure.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a malfunction
and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the contents are included.
Contents:
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
1. Remove the screw (#33) in the lower handle tube (#42). Insert the upper
tube (#44) into the lower tube's flared opening, aligning the screw holes.
Insert and tighten the screw to secure both halves of the handle.
2. Insert the handle into the handle socket (#40) and press until it is up
against the screw (#41).
3. Hold the handle down and cut the plastic tie holding the handle socket in
place. Hold the handle and allow the handle socket to raise into the rest
position.
4. Unscrew the screw (#41) by hand until it no longer protrudes into the
socket. Push the handle in as far as possible. Tighten the screw to lock the
handle in place.
5. Twist the handle left and right to ensure the release valve operates
smoothly. Tighten the screw if the handle rotates within the socket.
6. Check the hydraulic oil level and bleed the hydraulic system before using
for the first time (See Care and Maintenance).
Visit www.princessauto.com for more information
4 Ton Low Profile Floor Jack
• Low Profile Floor Jack • 2 Piece Handle
8760621
7