Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Keep-warm function
o
You can keep the tea or boiled water warm for up to 30 minutes.
o
The keep-warm function allows you to maintain a configured temperature. To do this,
press the «Keep warm» button to activate the keep-warm function. The illuminated
blue status ring of the button indicates that the keep-warm function is activated. To
turn off the keep-warm function, press the «Keep warm» button again. As soon as
the desired heating temperature is reached, it is maintained for about 30 minutes.
Press the «ON/OFF» button to interrupt this operation. If you remove the kettle from
the station during the keep-warm function, the appliance is switched to the standby
mode.
Adjusting the brewing temperature and steeping time
o
You can change the preset times as desired using the « » / « » buttons of the
individual temperature and time settings.
The temperature (individual temperature setting) can be adjusted between 70°C and
o
100°C in 5°C increments.
o
The brewing time (individual time setting) can be adjusted between 0:00 and 10:00
minutes in 30 seconds increments.
«AUTOSTART» - function
o
Using this function, you can pre-program the appliance to a desired time, so that your
appliance keeps the water or tea ready, e.g. in the morning for breakfast.
o
Fill the appliance with either water or tea and water. Always note the respective max-
imum filling levels.
o
To do this, press the «AUTOSTART» button until the blue status ring of the button
starts glowing.
o
The display now changes to the programming overview, which is indicated by the
small clock symbol « » at the top of the display.
In addition, two times are shown on the display. On the left is the «CURRENT TIME»,
o
which represents the present time. On the right, you can see the «START TIME» which
represents the switch-on time.
o
To adjust the times, press and hold the «AUTOSTART» button for 2 seconds.
o
The «CURRENT TIME / START TIME» indicators start flashing in the display.
o
The appliance now waits 20 seconds for your input. If there is no input during this
time, the appliance switches off and you will have to start the process again.
o
Now adjust the current time. To do this, use the « » / « » buttons of the indi-
vidual temperature setting, then the switch-on time using the « » / « » buttons of
the individual time setting.
o
When programming, pay attention to the 12-hour AM/PM classification (AM = mid-
night to noon / PM = 12 noon to midnight).
o
Close or activate the «AUTOSTART» function by pressing the «ON/OFF» button.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
40
Publicité
Table des Matières
